OK Im going to work based on that possible issue and get routing for non public IP's setup tomorrow. Thanks
Craig ----- Original Message ----- From: "Colin Stanners" <cstann...@gmail.com> To: af@afmug.com Sent: Thursday, April 7, 2016 10:13:05 PM Subject: Re: [AFMUG] Odd power cycling issues I'd say it's possible, the basic Cambium HTTP server may not be designed to survive pubic brute-forcing. On Thu, Apr 7, 2016 at 10:09 PM, Craig House < cr...@totalhighspeed.net > wrote: These devices are on public IP's . Our upstream for this tower just recently changed a bunch of routing and firewall stuff. Is it possible this is a brute force attempt that is overloading the radios in this subnet and causing the to reboot ?? Craig From: "Colin Stanners" < cstann...@gmail.com > To: af@afmug.com Sent: Thursday, April 7, 2016 10:03:18 PM Subject: Re: [AFMUG] Odd power cycling issues Could it be a problem with the GPS sync that's making the water tower reboot? As for the slave rebooting could be an old software bug? On Thu, Apr 7, 2016 at 9:55 PM, Craig House < cr...@totalhighspeed.net > wrote: <blockquote> I know this is old legacy FSK equipment but it is what is on the tower so we have an odd situation going on. Water tower fed with a 5.2 BH20 link from a bank that is 800' away. Only equipment in use on the tower is a 900 omni. The Master BH and the 900 omni are on a CMM at the base of the tower. For the last few days the equipment will reboot itself every 60 minutes or less on average. Not so odd that the CMM and the equipment on the tower reboots but so does the slave Bh at the bank at the exact same time. OK I thought Power issues, I replaced the UPS at the base of the tower. Problem still persists. I can find no place where the equipment can have a ping watchdog and there is not a web power switch at the base of the tower either. The odd part is that out of desperation I logged into the AP and the CMM and factory defaulted the devices and reconfigured them. When I rebooted the CMM to apply the reconfiguration, the Remote BH power cycled at the same exact time. This equipment has been in service for over 2 years and is running old firmware 9.3 on the BH20's but have never been a problem until now. I even changed the passwords thinking someone might be accessing them and causing these issues but I'm stumped. Craig </blockquote>