We have Frequency carrier set to 907 mhz currently so it is not on NONE. On Wed, Dec 21, 2016 at 3:52 PM, George Skorup <[email protected]> wrote:
> Yep, I noticed that too back on 14.1.2 and forgot to tell Cambium about > it. If the carrier frequency is set to None, the SA will not run. You can > try clicking the continuous spectrum analysis button below the timed button > and see if that works, but I don't think it does either if freq = None. > > On 12/21/2016 3:46 PM, Darin Steffl wrote: > > Hello, > > I'm following in the manual on how to initiate a timed spectrum scan. I > enter 30 seconds and then click "Start Timed Sector Spectrum Analysis" > > The problem is that nothing on this page changes. The results box at the > top still shows "Spectrum Analysis not performed". I've rebooted the radio, > updated to the latest 15.0.2 firmware and still no go. > > I'm following step-by-step in the 723 page manual and not having good luck > getting the spectrum analyzer to do anything for me. > > I'm in Chrome and maybe that's the problem. Any advice on how to get this > working? This is our first 450 radio so please bear with us. It took me 10 > mins to figure out CNUT and how to upgrade firmware. I was expecting to > upgrade via the GUI like ePMP and Ubiquiti ha > > Thanks > > -- > Darin Steffl > Minnesota WiFi > www.mnwifi.com > 507-634-WiFi > <http://www.facebook.com/minnesotawifi> Like us on Facebook > <http://www.facebook.com/minnesotawifi> > > > -- Darin Steffl Minnesota WiFi www.mnwifi.com 507-634-WiFi <http://www.facebook.com/minnesotawifi> Like us on Facebook <http://www.facebook.com/minnesotawifi>
