If it was PTMP then the ATPC needs to be turned on.
Josh Luthman Office: 937-552-2340 Direct: 937-552-2343 1100 Wayne St Suite 1337 Troy, OH 45373 On Mon, Jan 16, 2017 at 12:43 PM, Mathew Howard <[email protected]> wrote: > Can't really turn down power on a point to multi-point system... the AP > should already be turning down the TX power on the SM, if it's configured > properly. > > But it sounds like a good place to use a Force 180 instead of a 200. > > On Mon, Jan 16, 2017 at 11:28 AM, Josh Luthman < > [email protected]> wrote: > >> Please reduce the power for everyone's benefit. Go down to, ideally, >> -60. After changing power look at the performance and make sure it's still >> all MCS15. >> >> >> Josh Luthman >> Office: 937-552-2340 <(937)%20552-2340> >> Direct: 937-552-2343 <(937)%20552-2343> >> 1100 Wayne St >> Suite 1337 >> Troy, OH 45373 >> >> On Mon, Jan 16, 2017 at 12:23 PM, Chuck McCown <[email protected]> wrote: >> >>> Cambium posted something about this recently. >>> >>> I think you are still OK at that level. I think they said something >>> like signal problems starting at –35 and physical damage to the RX >>> components at –25 or some such figure. Be good to see that post again. >>> >>> *From:* Christopher Gray >>> *Sent:* Monday, January 16, 2017 10:05 AM >>> *To:* [email protected] >>> *Subject:* [AFMUG] How Hot is Too Hot for ePMP? >>> >>> I have a Force 200 receiving at -37 dBm. Is this ok, or do I need to >>> mis-align to reduce signal strength? >>> >>> >> >> >
