They will do 2 amps for a minute or so.
-----Original Message-----
From: Jon Langeler
Sent: Thursday, June 29, 2017 10:15 PM
To: [email protected]
Subject: Re: [AFMUG] Netonix rebooting over and over
1.5amp on VH ports I believe. Maybe your power supply or power cord isn't
supplying enough amps to the switch.
Jon Langeler
Michwave Technologies, Inc.
On Jun 29, 2017, at 11:42 PM, George Skorup <[email protected]>
wrote:
The Baicells 1-watt eNB @ 3.5/3.6GHz is about 65 watts. I haven't actually
measured this, but I can next week when I'm at one of those sites. So.. 4
of those would be 260 watts.
And I thought the Netonix 48VH POE mode is limited to 0.75A per port...?
Those eNBs are going to pull well over 1A per port.
On 6/29/2017 9:48 PM, Craig House wrote:
We install the DC powered Netonix 12 port switch today on the water tower
power off of 48 V power supply. The only device is powered off of the
switch are Baicells sectors all four of them are power off of 48 V ports
123 and 4. When we first installed them all of them powered up
individually on the CAT5 cables one at a time. We are using a 48 V POE
splitter that works fine at several of our other locations. At one point
we rebooted the DC powered switch and noticed that over and over and over
it would power on the ports in a soon as the radios would start power up
the entire switch with power cycle again. This happened about eight
times before I unplugged all four of the CAT5 cables from ports one
through four. Wants the switch had completely powered up I plug-in one
cable at a time and all of them powered up properly with gigabit ethernet
links. What I'm curious is. Number one why would the switch power cycle
over and over unless the initial build up of the LTE base stations is
substantially more than the power draw to run it on average normally?
And if that's the case is there a way that the switch can be configured
so that the ports don't power on all at the same time and I can set up a
power on delay for each port so that they each power on 5 to 10 seconds
after each other. ?? Has anyone else experienced this and what was your
solution I can switch back to an AC powered unit to see if that resolves
the problem but it seems that there shouldn't be that much of a voltage
draw to affect the DC power unit. Now that all four radios have been
running for several hours straight it's only showing 100 what's of the
draw on a device that should be able to handle 250
Sent from my iPhone
