My 45g is 10’ from The bottom of one section to the bottom of the section below it. So you get a full 10 feet out of each section. The 25g sections are 10 feet including the 4 inches that fits inside the other section so you lose 4 inches per section of Tower The stock I have is not rohn but I believe is identical to it and I have used it to stack on top of old Rohn sections
Sent from my iPhone > On Dec 4, 2017, at 08:19, Adam Moffett <dmmoff...@gmail.com> wrote: > > Ya know I never measured one. Is it actually 10' from bolt hole to bolt > hole? > > > ------ Original Message ------ > From: "Craig House" <cr...@totalhighspeed.net> > To: af@afmug.com > Sent: 12/3/2017 2:40:17 PM > Subject: Re: [AFMUG] Tower Question > >> That’s correct. >> >> Sent from my iPhone >> >>> On Dec 3, 2017, at 13:26, <ch...@wbmfg.com> <ch...@wbmfg.com> wrote: >>> >>> I find drawings showing 25G and 45G tower sections being 10’ end to end. >>> But that would cause the tower to lose a few inches due to the telescoping >>> at each junction between sections. So, I am guessing it is 10’ plus >>> whatever length telescopes when mating the sections. Line 4”?? >>> >>>