What about a single loop on the actual enclosure either at the
convergence of cables entry or at each connector?
something like a raised loop large enough to pass 1/4" zip tie and small
enough at each connector to pass a 1/8" zip
Dave
On 02/09/2018 09:30 AM, [email protected] wrote:
I am making a new tower mount multiple circuit surge protector.
This one is for multiple higher current DC power circuits/ conductors
only.
Trying to come up with a good way to allow the wires to be secured.
Right now I have a series of rectangular slots in the PCB so a zip tie
can be passed down behind the board and back up.
Any better ways?
--
