To comment on the following update, log in, then open the issue: http://www.openoffice.org/issues/show_bug.cgi?id=77162
------- Additional comments from [EMAIL PROTECTED] Fri May 11 10:22:37 +0000 2007 ------- AW: Stubled upon problem with implementation of setControlPointB. These would have to check with the follow-up point if vector is used or not. This laeds to the fact that setB2DPoint when setting B would also need to check with prev point and it's 2nd control vector. This is possible, but much to expensive. Base problem is the definition of the 2nd control point relative to the edge start. AW: Discussed with THB again. The plan is: (a) remove the vector interface, only point inerface plus used checks plus resets (b) go back to topology with prev and next control point at a point (c) add an append() which appends a whole edge with control points This involves changing set/getControlPointA/B -> also need projects drawinglayer, canvas, sc, sw. Dawinglayer needs to be changed in aw033. Adding canvas, sc and sw... --------------------------------------------------------------------- Please do not reply to this automatically generated notification from Issue Tracker. Please log onto the website and enter your comments. http://qa.openoffice.org/issue_handling/project_issues.html#notification --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]