To comment on the following update, log in, then open the issue: http://www.openoffice.org/issues/show_bug.cgi?id=81766
------- Additional comments from [EMAIL PROTECTED] Sat Feb 9 07:13:58 +0000 2008 ------- I still have several strange and annoying varable-problems. I use a standard header with variables containing project information for many documents. The advantage is that I have available complete project information for all standard documents of a project with a simple “copy / paste”. But again and again those formatting problems reappear and I see some numbers (mostly “0”) instead of the required project information in the “show variable” fields. Attached in my “testkit”you will find 2 folders “h” and “l” with similar sample documents, each with a master document and a slave document. In a test I copied /pasted the working “show variables” fields from “_inbetriebnahme_l.odt” to “_inbetriebnahme_h.odt”, where only numbers were shown in the master document view. Unfortunately, those pasted variables don't work either, even when I integrate that slave document with the new variables into the master document with the good working variable view for slave document “_inbetriebnahme_h.odt”. Steps to reproduce: 1. open both master documents in folder “h” and folder “l” and go to heading “Inbetriebnahme-Bericht”. Variable view in document from folder “h” should be destroyed, variable view for documents in folder “l” should work fine. 2. open both documents “_inbetriebnahme_.odt” and copy /paste the range from line above “Einsatz von” to line below“Planer:” from “_inbetriebnahme_l.odt” to corresponding area in document “_inbetriebnahme_h.odt” to replace those not working variable view fields. 3. Close and save slave documents. 4. open “h.odm” and go to Heading “Inbetriebnahme – Bericht” of “_inbetriebnahme_h.odt” expected: variable view should now work actual: still numbers will be shown. to test whether the variables in the master document might be the reason for the problem, no continue: 11. open “h.odm” 12. open Navigator 13. click on item “_inbetriebnahme.odt” 14. Insert file “_inbetriebnahme.odt_h” using the context menu 15. update all 16. go to Heading “Inbetriebnahme – Bericht” of “_inbetriebnahme_h.odt” expected: variable view should now work actual: still numbers will be shown. Strange! --------------------------------------------------------------------- Please do not reply to this automatically generated notification from Issue Tracker. Please log onto the website and enter your comments. http://qa.openoffice.org/issue_handling/project_issues.html#notification --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]