To comment on the following update, log in, then open the issue: http://www.openoffice.org/issues/show_bug.cgi?id=88521
------- Additional comments from [EMAIL PROTECTED] Wed Jun 4 15:16:50 +0000 2008 ------- Hello Niklas, I have a small question about the slider,if Scaling mode is Reduce/enlarge printout,Scaling factor is 200%, when the user switch from that mode to Fit to pages,the slider should disable,but I don't know how to set its position,there are two scenarios: 1).when the user select Fit to pages,it is disabled,the slider's position is 200%. 2).the other when the user select Fit to pages,it is disabled,the slider's position is 100%, meantime,when the user switch to Reduce/enlarge printout, Is the slider's position 100%? or Is the slider's position 200%? any better ideas? or better scenario? I hope you can give me some advice. thanks! --------------------------------------------------------------------- Please do not reply to this automatically generated notification from Issue Tracker. Please log onto the website and enter your comments. http://qa.openoffice.org/issue_handling/project_issues.html#notification --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]