Hi! I didn't get any answer on alsa-user list so I try here.
I have a Hoontech NX card with outputs for front and rear speakers. Volume settings for these I would like to set independently of each other, and this worked just fine while I was running ALSA 0.5.x. However, a couple of days ago I upgraded to ALSA 1.0.3. Now, there are two possibilities for controling volume settings on speakers, one with "Sigmatel 4-speaker stereo" off and another with this switch turned on. The second posibility (4-s s on), has following setup: - "Master" controls front speakers - "PCM" controls both front and rear speakers Sigmatel 4-speaker stereo off is almost what I want: - "Master", "PCM", "PCM Front" control front speakers - "Surrownd", "PCM Reverb" control rear speakers However, PCM Front and PCM Reverb are set to 100% resp. 0% each time /dev/dsp is opened. This works perfectly for front speakers since they can be controled with Master or PCM controls, but rear speakers are muted each time a new song starts. Is this a bug? (I hope it is.) Is it a known bug, or is it some kind of feature I can hope to be able to go around in future release of trident driver? Regards, -- Aner Gusic, Linköping Sweden ------------------------------------------------------- This SF.Net email is sponsored by Sleepycat Software Learn developer strategies Cisco, Motorola, Ericsson & Lucent use to deliver higher performing products faster, at low TCO. http://www.sleepycat.com/telcomwpreg.php?From=osdnemail3 _______________________________________________ Alsa-devel mailing list [EMAIL PROTECTED] https://lists.sourceforge.net/lists/listinfo/alsa-devel
