On Wed, Nov 21, 2007 at 05:49:43PM +0000, Chris Birkinshaw wrote: > So I can't use alsactl and amixer to restore levels from the command line? > amixer does not show any level controls either. To my knowledge you can not. Probably there's a command line option in hdspmixer for that, since you can save and restore settings on the graphical user interface. But I'm not sure about a command line option.
> Do you know why there are no PCMs listed? > > I wondered if it was a firmware problem, though all the messages in the > groups about that are quite old and I have a recent alsa driver. It's not > obvious what the current supported firmware version is. I can find 104 and > 106 on the RME website, but nothing older. It's definitely not a firmware issue, I have had my Digiface for quite some time, and it's always been like that. Probably it's a coice in driver design. Regards Christian -- ------------------------------------------------------------------------ Dipl.-Phys. Christian Schumann |Technische Universitaet Kaiserslautern Mail: [EMAIL PROTECTED] | Fachbereich Physik Tel.: 0631/205-4842 (Office) | http://www.physik.uni-kl.de Tel.: 0631/205-4843 (Lab) | Fax.: 0631/205-3902 | Post: Erwin-Schroedinger-Strasse, D-67663 Kaiserslautern ------------------------------------------------------------------------- ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2005. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ Alsa-user mailing list Alsa-user@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/alsa-user
