Now the client is a bit slow, a 500mhz K6-III, so I expected the level 0's this would cause would take a while. This also brought my disklist entries up to 44. The string that controls the dumporder in amanda.conf:
dumporder "SSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSSS"
*should* cause the largest first, then descending order, and there are enough S's to cover all DLE's such that once the first dump is ready, the drive streams till its done.
They all start together, but which dump will be ready first you think? It's probably one of the smaller dumps! I guess not all 44 dumpers will be active, because you probably have other constraints (maxdumpers per host, per disk, bandwith etc,).
Taper starts taping as soon it receives the first file to tape, and that's probably a smaller one.
Using less dumpers should work better.
-- Paul Bijnens, Xplanation Tel +32 16 397.511 Technologielaan 21 bus 2, B-3001 Leuven, BELGIUM Fax +32 16 397.512 http://www.xplanation.com/ email: [EMAIL PROTECTED] *********************************************************************** * I think I've got the hang of it now: exit, ^D, ^C, ^\, ^Z, ^Q, F6, * * quit, ZZ, :q, :q!, M-Z, ^X^C, logoff, logout, close, bye, /bye, * * stop, end, F3, ~., ^]c, +++ ATH, disconnect, halt, abort, hangup, * * PF4, F20, ^X^X, :D::D, KJOB, F14-f-e, F8-e, kill -1 $$, shutdown, * * kill -9 1, Alt-F4, Ctrl-Alt-Del, AltGr-NumLock, Stop-A, ... * * ... "Are you sure?" ... YES ... Phew ... I'm out * ***********************************************************************
