Glen
I'd check the logic in the kernel code that checks for 80 way cables etc etc. When I last looked at 2.4.19 it was doing some weird stuff - do the checks then reset the flag where the bit table for the capabilities of the drive is set. As opposed to reset, then do the checks!
I know you said you run 2.6.x but it's worth checking..
-- Martin Hepworth Snr Systems Administrator Solid State Logic Tel: +44 (0)1865 842300
Glenn English wrote:
On Wed, 2004-06-02 at 17:07, Frank Smith wrote:
If it's linux, try using hdparm to verify the modes and speed of your disk. Like Jon says, a good drive can have terrible performance if it is running in the wrong mode.
hdparm is a nifty addition to my system monitoring toolkit (top, gnome's cpu monitor icon, sticking my ear close to a drive to listen for seeks, eyeballing the disk activity LED, and dump's data transfer messages).
hdparm uncovered some interesting information. The 2 drives on this machine are identical and identically configured, except for one thing: both are using dma, but one of them, hda, is udma2 and hdc is udma5. I did a 'hdparm -X 69 /dev/hda' to set hda to udma5. hdparm said it did, but hdparm -i still said udma2.
Jon implied that hdparm may be just kidding about this. hdparm -Tt gives the following:
----
/dev/hda:
Timing buffer-cache reads: 2800 MB in 2.00 seconds = 1399.51 MB/sec
Timing buffered disk reads: 82 MB in 3.00 seconds = 27.33 MB/sec
/dev/hdc:
Timing buffer-cache reads: 2772 MB in 2.00 seconds = 1386.21 MB/sec
Timing buffered disk reads: 114 MB in 3.03 seconds = 37.62 MB/sec
----
Since I have no feel for what pio would be like, I don't know. But the difference looks ballpark right for the different dma modes.
I looked at another system: an old Dell server downstairs with a Maxtor PCI IDE card and a 2 or 3 year old Maxtor 60GB disk, also claiming to be udma5:
---- /dev/hde:
Timing buffer-cache reads: 128 MB in 0.59 seconds =216.95 MB/sec
Timing buffered disk reads: 64 MB in 1.59 seconds = 40.25 MB/sec
----
Something is wrong here. The disks up here are much newer, and a lot
slower. I'm using the onboard controllers in an Intel D865GLC
motherboard.
Also, make sure your kernel is using the correct chipset driver for your IDE controller. On a machine at home I replaced the motherboard and my disk speeds dropped to under 2MB/sec. I finally figured out that since I had a different controller than the one I had compiled in support for, the kernel had dropeed back to generic IDE support. Rebuilding the kernel with the proper driver made an over 10X performance boost.
That's where I'm going next. Kernel dox, motherboard dox, Gentoo dox, and hdparm's man page. And google, of course...
Does anyone know of an equivalent to hdparm -Tt for SCSI disks?
**********************************************************************
This email and any files transmitted with it are confidential and intended solely for the use of the individual or entity to whom they are addressed. If you have received this email in error please notify the system manager.
This footnote confirms that this email message has been swept for the presence of computer viruses and is believed to be clean.
**********************************************************************
