Howdy Folks! I'm new to these forums, and am also new to Amanda, and still trying to learn my way around Linux (i'm using Fedora 7).
When i first came across Amanda and decided to use it as my backup solution, i had found a 'how to' guide for configuring the software (http://robertolitrico.blogspot.com/2007/04/installing-and-configuring-amanda-in.html). However, this specific howto guide has a lot of stuff that is specific to using a robotic tape changer device. I have been going through the above referenced guide, attempting to follow it yet making alterations in the places i identified as being specific for a tape changer device, rather than a single tape drive. Unfortunately, i've got to a point where i'm both confused of what i'm doing and unsure of what i should make changes to, for my system as compared to what is outlined in that guide. (for what it's worth, i made it about halfway through that guide) I've tried to look for a basic how to guide to get me going, that wasn't meant specifically for a tape changer implementation with no such luck. If anyone could point me to a how-to guide for setting amanda up on linux, with a single scsi tape drive, which will be changed manually, i would be very grateful! Thanks much folks! +---------------------------------------------------------------------- |This was sent by [EMAIL PROTECTED] via Backup Central. |Forward SPAM to [EMAIL PROTECTED] +----------------------------------------------------------------------