On 01/09/17 02:10 PM, Chris Hoogendyk wrote:
OK.
So, how does the planner plan for what goes on each storage?
It doesn't, it use the size and plan to dump less than that.
That is, if I set up a pseudo tapetype
for global and give it a length of, say, 12.5TB; how will it know that
the uncompressed DLEs are
targeted to the LTO7 and the compressed DLEs are targeted at the LTO6?
What if the proportions came
out wrong (say, 8TB of DLEs intended for the LTO7 and 4.5TB of DLEs
intened for the LTO6), but the
total was within the 12.5TB?
That's the problem, some DLEs will fail unless you have enough holdingdisk.
I never liked the idea that amanda delay some full dump because it do
not have enough tape space, It get worse at every days
The solution to never hit that problem is to always provide enough tape,
you could increase the runtapes of both storage.
Also, there is no commentary in the Amanda email report indicating
where each DLE went, just the
overall amount of data that was written to each tape. I presume DLEs
are going to the intended
tapes, but . . . .
Where would you like the information to be printed.
You can run 'amadmin CONF find', it should list the storage for each DLEs.
Jean-Louis
This message is the property of CARBONITE, INC. and may contain confidential or
privileged information.
If this message has been delivered to you by mistake, then do not copy or
deliver this message to anyone. Instead, destroy it and notify me by reply
e-mail
