On Wed, Oct 14, 2020 at 13:20:38 -0400, Chris Hoogendyk wrote:
> I've been doing all the debugging stuff one one server. On my other
> server, I had simply set it to traditional and it's been working.
> Just now I went and applied ScanInventory.pm.patch_20201013C and
> changed the amanda.conf back to using oldest. An amcheck daily told
> me there were no acceptable volumes found! So I switched back to
Hmmm... Well, clearly the exact failure mode different between the two
servers :(.
(You did previously see the "terminated with signal 11" error message on
the eclogite server, right?)
Did the dump that ran yesterday/last night actually write to the
geo-daily-065 tape successfully, or was there some sort of changer error
at run time?
I guess the next thing to try would be to install
ScanInventory.pm.patch_20201013B to enable some debugging, then run
"amcheck -s" and "amtape ... taper" again and post the results. Those
tests should be done using the oldest taperscan, but you can leave the
amanda.conf as-is and test with -otaperscan on the command lines if you
prefer.
Also, since I assume the statefile has changed since you last posted it,
I guess you should include it again (i.e. the version that is out then
at the moemnt you are running those tests).
Nathan
----------------------------------------------------------------------------
Nathan Stratton Treadway - natha...@ontko.com - Mid-Atlantic region
Ray Ontko & Co. - Software consulting services - http://www.ontko.com/
GPG Key: http://www.ontko.com/~nathanst/gpg_key.txt ID: 1023D/ECFB6239
Key fingerprint = 6AD8 485E 20B9 5C71 231C 0C32 15F3 ADCD ECFB 6239
