Fix the following errors reported by checkpatch: ERROR: need consistent spacing around '/' (ctx:WxV) ERROR: code indent should use tabs where possible
Signed-off-by: Ran Sun <sunran...@208suo.com> --- drivers/gpu/drm/amd/pm/powerplay/hwmgr/vega12_hwmgr.c | 10 +++++----- 1 file changed, 5 insertions(+), 5 deletions(-) diff --git a/drivers/gpu/drm/amd/pm/powerplay/hwmgr/vega12_hwmgr.c b/drivers/gpu/drm/amd/pm/powerplay/hwmgr/vega12_hwmgr.c index 1937be1cf5b4..4bd573d815ff 100644 --- a/drivers/gpu/drm/amd/pm/powerplay/hwmgr/vega12_hwmgr.c +++ b/drivers/gpu/drm/amd/pm/powerplay/hwmgr/vega12_hwmgr.c @@ -1623,13 +1623,13 @@ static int vega12_notify_smc_display_config_after_ps_adjustment( if (data->smu_features[GNLD_DPM_DCEFCLK].supported) { clock_req.clock_type = amd_pp_dcef_clock; - clock_req.clock_freq_in_khz = min_clocks.dcefClock/10; + clock_req.clock_freq_in_khz = min_clocks.dcefClock / 10; if (!vega12_display_clock_voltage_request(hwmgr, &clock_req)) { if (data->smu_features[GNLD_DS_DCEFCLK].supported) PP_ASSERT_WITH_CODE( !smum_send_msg_to_smc_with_parameter( hwmgr, PPSMC_MSG_SetMinDeepSleepDcefclk, - min_clocks.dcefClockInSR /100, + min_clocks.dcefClockInSR / 100, NULL), "Attempt to set divider for DCEFCLK Failed!", return -1); @@ -2354,8 +2354,8 @@ static int vega12_apply_clocks_adjust_rules(struct pp_hwmgr *hwmgr) uint32_t i, latency; disable_mclk_switching = ((1 < hwmgr->display_config->num_display) && - !hwmgr->display_config->multi_monitor_in_sync) || - vblank_too_short; + !hwmgr->display_config->multi_monitor_in_sync) || + vblank_too_short; latency = hwmgr->display_config->dce_tolerable_mclk_in_active_latency; /* gfxclk */ @@ -2522,7 +2522,7 @@ static int vega12_set_uclk_to_highest_dpm_level(struct pp_hwmgr *hwmgr, dpm_table->dpm_state.hard_min_level = dpm_table->dpm_levels[dpm_table->count - 1].value; PP_ASSERT_WITH_CODE(!(ret = smum_send_msg_to_smc_with_parameter(hwmgr, PPSMC_MSG_SetHardMinByFreq, - (PPCLK_UCLK << 16 ) | dpm_table->dpm_state.hard_min_level, + (PPCLK_UCLK << 16) | dpm_table->dpm_state.hard_min_level, NULL)), "[SetUclkToHightestDpmLevel] Set hard min uclk failed!", return ret); -- 2.17.1