Hello Jan, you were faster than I could think of your problem. Yes, /everything/ needs to be initialized on reset. And yes, very strange things can happen, if you miss one little thing.
Glad you found it! Erich Jan Kromhout writes: > Hi, > > Also find the problem. > In my program I use buffers: to create an array. Never thought that these > will be cleared at a reset, and also the variables > used in my program . > After make an init and start this after a reset my application is working as > it should. > > Cheers, > > Jan > > > >> Op 12 nov. 2018, om 19:30 heeft Jan Kromhout <krom1...@hotmail.com> het >> volgende geschreven: >> >> Hi, >> >> After a few days of trial and error, I finally managed to control the >> 12c-LCD mine. >> A stupid interpretation caused the delay, eventually solved. >> My tests are running well. >> >> But now it comes. When I give a reset of the Arduino and afterwards I want >> to write a value to the LCD then it simply does not work. >> After reset I init the I2C again. When I check with $38 i2c.ping? I get back >> the true (-1) value. The i2c.status is $f8, but I can’f fint the >> meaning of this value. >> >> When I check the I2C bus with logic analyser no activity. >> >> Only when I re-load the application it does run again. >> >> >> Any idea what that could cause? >> >> Cheers, >> >> Jan >> >> >> >> _______________________________________________ >> Amforth-devel mailing list for http://amforth.sf.net/ >> Amforth-devel@lists.sourceforge.net >> https://lists.sourceforge.net/lists/listinfo/amforth-devel > > > _______________________________________________ > Amforth-devel mailing list for http://amforth.sf.net/ > Amforth-devel@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/amforth-devel -- May the Forth be with you ... _______________________________________________ Amforth-devel mailing list for http://amforth.sf.net/ Amforth-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/amforth-devel
