Thomas,
Thanks.
Yes, I am calculating many arrays inside a loop, but I have limited
them to 2000 bars each by parameter. It is a bit much to post it at
this stage. Using TJ's suggestions the apply time is down to a
minute. Reducing my loops to 200 bars has reduced it to 40 seconds.
Best regards,
Dennis
On Sep 4, 2007, at 5:39 PM, Thomas Z. wrote:
Hello,
Maybe you are calculating a complete array inside a loop.
Post your loop to check.
Kind regards
Thomas
www.patternexplorer.com
From: [email protected] [mailto:[EMAIL PROTECTED]
On Behalf Of Dennis Brown
Sent: Tuesday, September 04, 2007 11:25 PM
To: [email protected]
Subject: [amibroker] Why does it take so long to apply edits?
Hello,
I have noticed that the time it takes to apply an edit to my large
indicator AFL takes a long but variable amount of time. It might
take 15 seconds one time and 3 minutes another time. It usually
takes about 2.5 minutes to apply an edit, though if there is a syntax
error, it comes back right away. The AFL itself has an execution of
about 1 second per pass and starts up right away from scratch.
I was wondering if there were any general rules that I should be
aware of that would make applying edits faster and more consistent?
Another thing that is interesting is that if I click anywhere on the
chart or UI while the edit is being applied, it runs even slower, and
always resets all the params.
Insights anyone?
Thanks,
Dennis
