Installed a new 20K/200 watt resistor in the screen circuit to the 4-400A's. There are two of these resistors in series - I replaced the other one some time ago. The problem was none other than an open resistor. I did see a whitish power on one end of the resistor which is a sure sign that the resistor was overheated and open.
What happened when I had no screen voltage on the 4-400A's. Well, there was no load on the high voltage power supply which caused the voltage to rise to over 4,000 volts. This higher than normal voltage created some kind of corona effect inside the meter or whatever. The meter now reads perfectly once I got the transmitter loaded and with screen voltage applied. The screen voltage is taken off the high voltage and reduced through two 20K high wattage resistors. Now the transmitter performs as it should. This was a tough problem but could have been easily solved had I checked these two resistors. No wonder I was not getting any output. Pretty obvious now but not several days ago. To those who sent me some suggestions via email - thank you. Dave, W3ST Publisher of the Collins Journal Secretary to the Collins Radio Association www.collinsra.com Nets: 3805 Khz, Monday/Wednesdays 8 PM EDST 14250 Khz Saturday, 12 Noon EDST