Possibly this is not quite correct forum for my question. However, most likely you know the correct answer.
I try to patch u-boot-denx for beaglebone with procedures below: 1) bitbake -f -c patch u-boot-denx 2) source editions in workdir 3) bitbake -f -c compile u-boot-denx What happens is that command at 3) executes: do_patch do_configure and do_compile. As a consequence editions are lost. I also tested just: bitbake -f -c patch u-boot-denx bitbake -f -c configure u-boot-denx resulting: do_patch do_patch do_configure Running commands below: bitbake -f -c patch u-boot-denx bitbake -f -c configure u-boot-denx bitbake -f -c configure u-boot-denx Gave tasks below: do_patch do_patch do_configure do_configure Now the question: Is there any trick to make those edition after patching so that patching is not run again by following do_configure? best regards, Matti _______________________________________________ Angstrom-distro-devel mailing list Angstrom-distro-devel@linuxtogo.org http://lists.linuxtogo.org/cgi-bin/mailman/listinfo/angstrom-distro-devel