I built an image for the ipaq hx4700 from the latest branch, installed it to the SD card. It boots but then stalls and the login prompt does not show. Here is the output when booting. [ 0.390000] ads7846_ssp: Using SSP2 [ 0.400000] asic3: using irq 160-229 on irq 44 [ 0.400000] SoC: registering ds1wm [ 0.410000] EGPIO phys=14000000 virt=c4804000 [ 0.420000] pxa2xx-udc-gpio: Generic driver for GPIO-controlled PXA2xx UDC [ 0.430000] Time: pxa_timer clocksource has been installed. [ 0.440000] NET: Registered protocol family 2 [ 0.540000] IP route cache hash table entries: 1024 (order: 0, 4096 bytes) [ 0.540000] TCP established hash table entries: 2048 (order: 2, 16384 bytes) [ 0.550000] TCP bind hash table entries: 2048 (order: 1, 8192 bytes) [ 0.560000] TCP: Hash tables configured (established 2048 bind 2048) [ 0.560000] TCP reno registered [ 0.600000] hx4700 Core Hardware Driver [ 0.600000] Stock HTC WM2005 bootloader detected [ 0.610000] hx4700 NavPoint Driver [ 0.610000] hx4700_navptd: receive thread started. [ 0.620000] input: NavPoint Device as /class/input/input0 [ 0.670000] egpio set: reg 0 = 0x0010 [ 0.680000] asic3: irq type not changed. [ 0.680000] egpio clear: reg 0 = 0x0000 [ 0.950000] hx4700 LCD Driver [ 1.020000] PXA CPU frequency change support initialized [ 1.030000] JFFS2 version 2.2. (NAND) (C) 2001-2006 Red Hat, Inc. [ 1.040000] io scheduler noop registered (default) [ 1.040000] Corgi Backlight Driver Initialized. [ 1.050000] Found w3220 at 0x08000000. [ 1.110000] Console: switching to colour frame buffer device 60x80 [ 1.140000] fb0: w100fb frame buffer device [ 1.140000] egpio set: reg 0 = 0x0010 [ 1.230000] pxa2xx-uart.0: ttyS0 at MMIO 0x40100000 (irq = 22) is a FFUART [ 1.240000] pxa2xx-uart.1: ttyS1 at MMIO 0x40200000 (irq = 21) is a BTUART [ 1.250000] pxa2xx-uart.2: ttyS2 at MMIO 0x40700000 (irq = 20) is a STUART [ 1.260000] pxa2xx-ir-serial: Initialized [ 1.260000] pxa_gpiodev_set_value(32, 1) [ 1.280000] RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 block size [ 1.290000] Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2 [ 1.290000] ide: Assuming 50MHz system bus speed for PIO modes; override with idebus=xx [ 1.310000] Probing hx4700-part0 at physical address 0x00000000 (32-bit bankw idth) [ 1.310000] hx4700-part0: Found 2 x16 devices at 0x0 in 32-bit bank [ 1.320000] Intel/Sharp Extended Query Table at 0x010A [ 1.330000] Intel/Sharp Extended Query Table at 0x010A [ 1.330000] Intel/Sharp Extended Query Table at 0x010A [ 1.340000] Intel/Sharp Extended Query Table at 0x010A [ 1.340000] Intel/Sharp Extended Query Table at 0x010A [ 1.350000] Using buffer write method [ 1.350000] cfi_cmdset_0001: Erase suspend on write enabled [ 1.360000] Probing hx4700-part1 at physical address 0x04000000 (32-bit bankw idth) [ 1.370000] hx4700-part1: Found 2 x16 devices at 0x0 in 32-bit bank [ 1.370000] Intel/Sharp Extended Query Table at 0x010A [ 1.380000] Intel/Sharp Extended Query Table at 0x010A [ 1.380000] Intel/Sharp Extended Query Table at 0x010A [ 1.390000] Intel/Sharp Extended Query Table at 0x010A [ 1.400000] Intel/Sharp Extended Query Table at 0x010A [ 1.400000] Intel/Sharp Extended Query Table at 0x010A [ 1.410000] Using buffer write method [ 1.410000] cfi_cmdset_0001: Erase suspend on write enabled [ 1.420000] Concatenating MTD devices: [ 1.420000] (0): "hx4700-part0" [ 1.420000] (1): "hx4700-part1" [ 1.430000] into device "hx4700-mtd" [ 1.430000] cmdlinepart partition parsing not available [ 1.440000] hx4700 MTD: using built-in partition definitions [ 1.440000] Creating 5 MTD partitions on "hx4700-mtd": [ 1.460000] 0x00000000-0x00100000 : "bootloader" [ 1.480000] mtd: Giving out device 0 to bootloader [ 1.490000] 0x00100000-0x00300000 : "kernel" [ 1.510000] mtd: Giving out device 1 to kernel [ 1.530000] 0x00300000-0x04fc0000 : "root" [ 1.540000] mtd: Giving out device 2 to root [ 1.560000] egpio set: reg 0 = 0x0010 [ 1.580000] egpio set: reg 0 = 0x0010 [ 1.590000] 0x04fc0000-0x07fc0000 : "home" [ 1.610000] mtd: Giving out device 3 to home [ 1.630000] 0x07fc0000-0x08000000 : "asset" [ 1.640000] mtd: Giving out device 4 to asset [ 1.660000] pxa27x_udc: version 01-01-2006 [ 1.680000] pxa_gpiodev_set_value(76, 0) [ 1.690000] input: gpio-keys as /class/input/input1 [ 1.710000] pccard: PCMCIA card inserted into slot 0 [ 1.730000] pcmcia: registering new device pcmcia0.0 [ 1.750000] input: ts-adc as /class/input/input2 [ 1.770000] sa1100-rtc sa1100-rtc: rtc core: registered sa1100-rtc as rtc0 [ 1.800000] Driver for 1-wire Dallas network protocol. [ 1.810000] DS1WM w1 busmaster driver - (c) 2004 Szabolcs Gyurko [ 1.870000] 1-Wire driver for the DS2760 battery monitor chip - (c) 2004-20 05, Szabolcs Gyurko [ 1.900000] APM Battery Driver [ 1.920000] Registered led device: hx4700:amber [ 1.940000] Registered led device: hx4700:green [ 1.960000] Registered led device: hx4700:blue [ 1.970000] TCP cubic registered [ 1.990000] NET: Registered protocol family 1 [ 2.000000] NET: Registered protocol family 17 [ 2.020000] XScale iWMMXt coprocessor detected. [ 2.040000] egpio set: reg 0 = 0x0010 [ 2.050000] egpio set: reg 0 = 0x0010 [ 2.420000] hda: Hitachi XX.V.3.4.0.0, CFA DISK drive [ 3.510000] ide0 at 0xc4820000-0xc4820007,0xc482000e on irq 92 [ 3.530000] hda: max request size: 128KiB [ 3.550000] hda: 2002896 sectors (1025 MB) w/1KiB Cache, CHS=1987/16/63 [ 3.580000] hda: hda1 [ 3.590000] ide-cs: hda: Vpp = 0.0 [ 3.610000] sa1100-rtc sa1100-rtc: setting the system clock to 1995-03-02 12: 01:16 (794145676) [ 3.640000] asic3_mmc: ASIC3 MMC/SD Driver, controller at 0xe000000 [ 3.730000] Waiting 5sec before mounting root device... [ 4.450000] mmcblk0: mmc0:1234 SD256 248064KiB [ 4.460000] mmcblk0: p1 p2 [ 8.750000] EXT2-fs warning: mounting unchecked fs, running e2fsck is recomme nded [ 8.780000] VFS: Mounted root (ext2 filesystem). [ 8.800000] Freeing init memory: 100K [ 12.130000] pxa_gpiodev_set_value(76, 0) [ 12.150000] ether gadget: using random self ethernet address [ 12.170000] ether gadget: using random host ethernet address [ 12.200000] usb0: Ethernet Gadget, version: May Day 2005 [ 12.220000] usb0: using pxa27x_udc, OUT ep2out-bulk IN ep1in-bulk STATUS ep3i n-intr [ 12.250000] usb0: MAC 46:59:9c:a7:dc:ba [ 12.270000] usb0: HOST MAC 6a:f2:6e:b7:15:4c [ 12.280000] usb0: RNDIS ready [ 12.410000] pxa_gpiodev_set_value(76, 1) [ 12.550000] Bluetooth: Core ver 2.11 [ 12.570000] NET: Registered protocol family 31 [ 12.590000] Bluetooth: HCI device and connection manager initialized [ 12.620000] Bluetooth: HCI socket layer initialized [ 12.690000] Bluetooth: L2CAP ver 2.8 [ 12.700000] Bluetooth: L2CAP socket layer initialized [ 12.810000] Bluetooth: HIDP (Human Interface Emulation) ver 1.2 [ 12.870000] hx4700 Bluetooth Driver [ 13.350000] NET: Registered protocol family 10 [ 13.680000] NET: Registered protocol family 23 [ 13.750000] IrCOMM protocol (Dag Brattli) [ 13.950000] Bluetooth: RFCOMM socket layer initialized [ 13.960000] Bluetooth: RFCOMM TTY layer initialized [ 13.980000] Bluetooth: RFCOMM ver 1.8 [ 14.520000] I2C: i2c-0: PXA I2C adapter [ 14.540000] I2C: i2c-1: PXA I2C adapter [ 14.560000] SACR0 = 0x7704, SADIV = 0xd [ 14.600000] PXA2xx i2Sound: hx4700 Audio activated root: mount: /sys already mounted or /sys busy root: mount: according to mtab, sysfs is already mounted on /sys ALSA: Restoring mixer settings /usr/sbin/alsactl: load_state:1625: No soundcards found... Configuring network interfaces... ifconfig: SIOCGIFFLAGS: No such device ifconfig: SIOCGIFFLAGS: No such device eth0 No such device ifconfig: SIOCGIFFLAGS: No such device done. Starting portmap daemon: portmapportmap: fork: No such device. net.ipv4.conf.default.rp_filter = 1 net.ipv4.all.rp_filter = 1 hwclock can't open '/dev/misc/rtc': No such file or directory Fri Sep 2 18:04:00 BST 2011 hwclock can't open '/dev/misc/rtc': No such file or directory Turning echo of on /dev/ttyS1 /etc/rcS.d/S97blueprobe: line 6: can't open /dev/ttyS1 :no s uch file
So over here it stalls at the end and moves no further. The login prompt does not show even in a serial connection. What can I do to make it work? _______________________________________________ Angstrom-distro-users mailing list Angstrom-distro-users@linuxtogo.org http://lists.linuxtogo.org/cgi-bin/mailman/listinfo/angstrom-distro-users