We are using "strict qw(vars subs)" - use "strict qw(refs)" is not possible by design. To use "strict refs" we have to make a complete redesign of ASSP. These changes were made to go forward to the multithreading mode of ASSP. For this a "strict refs" in not needed".
Thomas
[EMAIL PROTECTED] schrieb: -----An: ASSP development mailing list <[email protected]>
Von: "Daniel L. Miller" <[EMAIL PROTECTED]>
Gesendet von: [EMAIL PROTECTED]
Datum: 21.03.2008 18:39
Thema: Re: [Assp-test] This normal now?
Fritz Borgstedt wrote:
> 1.3.5 and 1.3.6 are now "strict" savy.
>
I have noticed the increased use of "strict" in ASSP - it has been
welcome. But in previous versions (including 1.3.5-18.4) I see "strict"
only applied partially ("use strict qw(vars subs)" instead of just "use
strict") . Is it your intent to use "strict" unconditionally?
--
Daniel
-------------------------------------------------------------------------
This SF.net email is sponsored by: Microsoft
Defy all challenges. Microsoft(R) Visual Studio 2008.
http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________
Assp-test mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/assp-test
*******************************************************
This email and any files transmitted with it may be confidential, legally privileged and protected in law and are intended solely for the use of the
individual to whom it is addressed.
This email was multiple times scanned for viruses. There should be no known virus in this email!
------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________ Assp-test mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/assp-test
