Hi,
You need to be careful as you will need it to do some form of xover to the
pbx. I am fairly sure the AVM B1 active card will not allow you to do that.
I "think" the Digium T/E1 card will which I "think" is supported. Have a
look at the BSD zaptel driver.
You may be better of chatting in the general discussion list about what you
want to do.
E-Bay is a lot cheaper for the active cards. I got a few AVM B1 cards for
15 euros each!
Chris
----- Original Message -----
From: "Matthias Fechner" <[EMAIL PROTECTED]>
To: <[email protected]>
Sent: Tuesday, July 05, 2005 3:35 PM
Subject: Re: [Asterisk-bsd] Which hardware i should use?
Hello Johannes,
* Johannes Ton <[EMAIL PROTECTED]> [05-07-05 16:28]:
Thats right, AVM's FritzCards works only with isdnd but not wih
Asterisk yet. There were discussions on [EMAIL PROTECTED] about passive
cards and asterisk but I think there isn't a solution yet.
ah ok, what i found too, is that the passive cards has bad delay, so i
will buy i active cards. thx a lot!
I've setup up a system such this and it works well for me.
a great, that is what i want to here :)
Thx a lot!
--
Bye
Matthias
_______________________________________________
Asterisk-BSD mailing list
[email protected]
http://lists.digium.com/mailman/listinfo/asterisk-bsd
_______________________________________________
Asterisk-BSD mailing list
[email protected]
http://lists.digium.com/mailman/listinfo/asterisk-bsd
