I have been playing around with this since Friday and I am now so confused I cannot figure why way though without asking a few questions.
I purchase a CMI 8738 because of it's full duplex capability so that I could use it during development with asterisk. I also purchased a Digium X100p card for the same reason. I have successfully managed to get the xa100p card working and can dial in and get the answer message so I know the card is working. My real problem is with the 8738. I have found that Redhat 9, which I am using has built in support for the card so even though I compiled a new kernel with this support I have not installed it as the support was already in place. I also have sound on the board using i810 so I actually have two sound cards. I have tested them both and they work happily. The question is how do I get Asterisk to recognise the 8378 card and allow full duplex to work. It seems that if I rotate which one is first or second e.g. in 'modules.conf' alias sound-slot-0 i810_audio alias sound-slot-1 cmpci Or the other way around asterisk still gives an error the error is exactly: WARNING[107438140]: File chan_oss.c, Line 419 (sound_init): Unable to open /dev/dsp: Device or resource busy == No sound card detected --console channel will be unavailable What am I doing wrong? And help would be gratefully received. Fats. _______________________________________________ Asterisk-Dev mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-dev
