On 10/17/2005, "James Sizemore" <[EMAIL PROTECTED]> wrote: > Doubling the value to 500 did not seem to effect the length of the > tone played at all....hmmmmm. Back to the drawing board for me. > Anyone know what this value is supposed to effect? > >>> I have a gateway using a Digium card to convert a PRI >>> call to a sip call then I transport the sip call to a Cisco >>> IAD where it is converted back to a PRI. This all works >>> well except DTMF is sent with a duration of .25sec. >>> PRI specs says this should be .25sec to .5sec so this >>> is with in spec, however the PBX on the other side of >>> the IAD does not reliable work with the DTMF tones >>> the minimum allowable length. I found in the INFO packets >>> where the DTMF is set to a duration or 250, I would like >>> to change this to 500. >>> >>> Which file and class would be the correct place to change >>> this value at?
Since it is the duration of the DTMF that goes INTO the PRI, I would be looking at where that happens - the Cisco config or the Digium config. Don't know a thing about the Cisco - but there is a toneduration in the zapata.conf. Since you say you get a call from the Digium card -> SIP -> Cisco -> PRI I really think you need to look at the Cisco. Brett _______________________________________________ Asterisk-Dev mailing list Asterisk-Dev@lists.digium.com http://lists.digium.com/mailman/listinfo/asterisk-dev To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-dev