Bob, There is, but it was intended to be limited to the scope of appliances as those have known defaults. Any other installation would have unknown defaults and any reset could cause data loss or other undesired effects.
However, since the GUI runs only on Asterisk config files, you can simply go into your Asterisk (not GUI) source dir and run 'make samples', this will re-install the sample configs which would effectively act as a reset of information. Note: You'd also have to change your http.conf and manager.conf settings back however. -- Ryan Brindley Digium, Inc. | Software Developer 445 Jan Davis Drive NW - Huntsville, AL 35806 - USA main: +1 256-428-6000 fax: +1 256-864-0464 Check us out at: http://digium.com & http://asterisk.org ----- Original Message ----- From: "Bob Crandell" <[email protected]> To: "Asterisk GUI" <[email protected]> Sent: Friday, July 10, 2009 7:52:14 PM GMT -06:00 US/Canada Central Subject: [asterisk-gui] Factory Reset Item Type: Note Date: Friday, 10 Jul 2009 Hi, Didn't there used to be a button to reset Asterisk back to factory fresh? Did it get moved? Is it hiding? Thanks Bob Crandell Assured Computing, Inc. 541-868-0331 ComputerBase USA 541-349-0404 _______________________________________________ --Bandwidth and Colocation Provided by http://www.api-digital.com-- asterisk-gui mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-gui
_______________________________________________ --Bandwidth and Colocation Provided by http://www.api-digital.com-- asterisk-gui mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-gui
