crc ? Try: span=1,0,0,ccs,hdb3,crc4 Konrad
-----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of [EMAIL PROTECTED] Sent: Friday, March 07, 2003 3:03 AM To: [EMAIL PROTECTED] Subject: [Asterisk-Users] Re: Tormenta ISA E1 card If I comment all lines of zaptel.conf,after I run the ztcfg,the warning in the zttool is OK, that is to say,no warning. If I leave the zaptel.conf's content as: span=1,0,0,ccs,hdb3 span=2,0,0,ccs,hdb3 then the RED warning will appear. I I connect a "loop back" line into span1's RJ45 socket,then the warning become RED/YELLOW. if I config the span1 as PRI_NET and span2 as PRI_CPE and connect them with a cable ,after I run the asterisk with -vvvvc,I could see the Tor channels are started. But when I dial the extenion based on zaptel's channel,I always got the information that the channel is busy. (if I change the chip and crystal to T1's,then all is OK!) Regards john Steve Underwood writes: > [EMAIL PROTECTED] wrote: > >> Hi,Steve, >> My ISA E1 card does not work yet. I would like to know if there are >> other difference bettween then two kind of ISA card? > > The crystals, the framer chips and the jumpers are the only differences. > What are the symptons of it not working? > > Regards, > Steve > > > > _______________________________________________ > Asterisk-Users mailing list > [EMAIL PROTECTED] > http://lists.digium.com/mailman/listinfo/asterisk-users _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users