Thanks for your good advice. > You shouldn't need ZERO_BATT_RING unless you're using a line coming off > of a TA, and if you are then you may not get disconnect supervision, > depending on your TA. > In any case, the disconnect supervision (AKA CPC) on PSTN lines in > Japan is very very short. > Look in wcfxo.c and play with the value of BATT_DEBOUNCE. Try lowering > it until you get hangup detection. > You may also want to verify that you _are_ receiving the CPC signal. > Either use an analog multimeter across the line or hold down the tone > on a line-powered tone phone while the calling party hangs up and see > if the tone or voltage goes away, even very briefly.
I had checked to detect supervision signal via TA, and verify recieved signal is good, by multimeter. And change the value of BATT_DEBOUNCE in wcfxo.c lowering. But often X100P doesn't get hangup detection.(but often get hangup detection) So, I had changed config to decetet by busy tone, but not the disconnect supervision. And then, it works well, Now. I will trying to use by this config, for several days. thanks. P.S. ->TokyoJimu Are you staying in Japan? ----------------------------- Shinsuke,Iwata Japan [EMAIL PROTECTED] _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users