Try the new_codec_binary/codec_g729b.so from the digium ftp site. regards Martin
On Wed, 23 Jul 2003, Dan Fernandez wrote: > I am having some problems with g729 with SIP and ZAP channels. > > 1) > I have two g729 licences. Very frequetnly (I donīt know what triggers the error) I > get the following warnings and error when I try to place a call via SIP to my X100P. > The only way to get out of this is through a restart of *. When the error ocurrs > there are no other calls in place. Any ideas? > > > Error Opening channel:2 not available, see va_g729_init_global(..) > WARNING[71694]:File codec_g729b.c line 102 (g729lin_new): No available g729b > resource for channel 2 > WARNING:[71694] File translate.c Line 111 (ast_translator_build_path):Failed to > build translator path from 8 to 6 Zap1-1 answered SIP/105-ce3c > WARNING[71694]: File chan_zap.c Line 3367 (zt_write):Cannot handle frames in 256 > format > Hangup Zap/1-1 > > > 2) > have discovered a problem when using g729 under the following setup: > > SIP call between a Budgetone 102 and ATA 186 (configured without silence > suppresion). Both ends have a ADSL 64kbps. Both ends are behind Linksys routers. The > pings between them are aprox. 100ms. No other local users on each end. * is being > hosted on a PIII,128MB. No other calls are being handled at the time of the test. > > Basically, after a few minutes, with g729, both ends consistently start getting > delays up to a point where it becomes almost unbearable to speak. If we switch to > g723 the problem goes away. > > ANy ideas whatīs going on? > > _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users