did you happen to run ztcfg after you setup the configs? On Sat, 9 Aug 2003, Barry Porch wrote:
> I am attempting to set up an Asterisk box which I am only concerned with > getting a single T1 working. I have this T1 connected to my PBX and I > am looking at using Asterisk as a conference bridge. > > Here is my zaptel.conf: > > span=1,1,0,d4,ami > e&m=1-24 > loadzone=us > defaultzone=us > > Here is my Zapata.conf: > > [channels] > language=en > context=default > signalling=em_w > group=1 > channel=1-24 > > As you can see I am trying to set this up as a D4/AMI E&M T1. I also > have "modprobe zaptel" and "modprobe wct1xxp" in my rc.local. > > When I try to run Asterisk it complains that it cannot access channel 1 > and dies. > > I can run zttool which "sees" the T100 card that I have installed. > However, when I run "ztcfg -vvvv" it sells me that 0 channels are > configured. > > What am I missing here? > > Thanks! > > Barry > _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users