I have three Cisco 7960 phones/SIP 5.3 using two Wildcard X100Ps and IAX service from Nufone. It worked fine on my earlier installed CVS from 6/10. I have not noticed any random hangs, altough it has only been running for two days.
Thanks, Marcus -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Todd Lieberman Sent: Wednesday, August 20, 2003 11:21 AM To: [EMAIL PROTECTED] Subject: RE: [Asterisk-Users] reload not working Martin - et all, I'm having the same issue. I have a PRI T1 on a T100P with six 7940 Cisco Phones w/SIP load 4.4. What hardware do u have? The worst part is that my system will sometimes just busy out even if I do not issue a reload command! However if I issue reload it's a sure thing * will hang. I spoke w/[EMAIL PROTECTED] about this last week but we never resolved it and my system has been hung 3 times in two weeks. Each time it hangs I killall -9 asterisk, cvs update & restart. He said he was working on the releasing of a PRI channel code last week and that the Telco and * may not be jiving correctly. I had the problem w/the 7/8/2003 cvs so the issue probably still exists. I'll report any findings from asterisk -vvvvvvvvvvvvgc as soon as I find any on my side, I just don't want to take down * during business hours. So tonight I'll restart w/asterisk -vvvvvvvvvvvvgc try and get to the bottom of this w/you. TL Here is what he [EMAIL PROTECTED] recommended: > Well if you use sip phones you might want to have "sip debug" turned > on. But if you have many SIP phones then you're going to have lots of > SIP messages. > The "zap show channels" output is broken. It might show some false > messages. Instead do "zap show channel <chann_no>" If the PRI Flag is > "Call" then this channel hasn't been cleared properly. If it's empty > than it's ok. If the channel is not serviced by your telco it's going > to be in "Restarting" state. > > Also make sure then when you restart asterisk that all the 23 channels > get restarted at the very begining. > > regards > Martin -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of Marcus Adolfsson Sent: Wednesday, August 20, 2003 9:05 AM To: [EMAIL PROTECTED] Subject: [Asterisk-Users] reload not working I upgraded to the latest CVS yesterday (and this morning again), and whenever I execute the reload command Asterisk seems to hang. While the current calls aren't dropped, no new calls can be made. The CLI isn't responding properly either. The only way to get going again is to exit the CLI and stop Asterisk and start again. Any comments? Thanks, Marcus _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users