> -----Original Message----- > From: [EMAIL PROTECTED] [mailto:asterisk-users- > [EMAIL PROTECTED] On Behalf Of Paul > Sent: Sunday, August 28, 2005 7:48 AM > To: Asterisk Users Mailing List - Non-Commercial Discussion > Subject: Re: [Asterisk-Users] T1 DSU's/Split for voice > > [EMAIL PROTECTED] wrote: > > >Hello All, > >I was wondering if I could do the following on asterisk... > > > >Get a T1 between 2 locations, and split it into a data channel of like > >1024, and use the rest for voice channels. > > > >Has anyone done this and had it working well? Or would I need to get a > >csu that allows a split into two interfaces? > > > >Regards, > >Greg > > > > > On a point-to-point t you will need hardware to split channels at both > ends. > > Since you posted to this list I assume that * is used at least on one > end of the t1. If you use good routers that can prioritize voip traffic > then all you need is ata's and/or ip phones at the other end. That gives > you more data bandwidth when the phones are not in use. Segregating n/24 > of your t is not so flexible. > That would be one way to do it, but both the Digium cards and the sangoma cards can be configured to route some of the 24 timeslots on a T1 to voice and some to data. _______________________________________________ --Bandwidth and Colocation sponsored by Easynews.com --
Asterisk-Users mailing list Asterisk-Users@lists.digium.com http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users