Normally the way I do it is to program the failover into the dialplan and then
send the call to Local/[EMAIL PROTECTED] to initiate it.
How about a snippet? (Local channels somewhat escape me.)
On Mon, 29 Aug 2005, Matt Riddell wrote:
Geoff Karl wrote:
I am currently using the Manager API to place a few calls. I have more than
one VSP available.
I was wondering how to best tell a call failed to move on to the next VSP.
I see messages like this, which is an obvious failure, and I would then move
on to the next VSP.
Normally the way I do it is to program the failover into the dialplan and then
send the call to Local/[EMAIL PROTECTED] to initiate it.
That way if you roll the software out to clients (who may have 1 or 100 or 100
providers set up) then they will not need to make alterations.
BTW: Rather than checking for all of the possible failures that could occur
why not just check for a success or lack thereof.
--
Cheers,
Matt Riddell
_______________________________________________
http://www.sineapps.com/news.php (Daily Asterisk News - html)
http://www.sineapps.com/rssfeed.php (Daily Asterisk News - rss)
_______________________________________________
--Bandwidth and Colocation sponsored by Easynews.com --
Asterisk-Users mailing list
Asterisk-Users@lists.digium.com
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
Thanks in advance,
------------------------------------------------------------------------
Steve Edwards [EMAIL PROTECTED] Voice: +1-760-468-3867 PST
Newline [EMAIL PROTECTED] Fax: +1-760-731-3000
_______________________________________________
--Bandwidth and Colocation sponsored by Easynews.com --
Asterisk-Users mailing list
Asterisk-Users@lists.digium.com
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
