Hello Filippo,
What revision of TDM400P do you have? Is it
REV I?
I have REV I and had the same problem
before. I had problem when I connected the FXO port to the all plug using 4
wires phone cable. It turned out that the RJ11 port of FXO or FXS in REV I, does
not work when pin 1 and pin 4 are connected to something. My problem was
solved after I changed the cable to 2 wires phone cable.
Cheers,
Anto
----- Original Message -----
Sent: Friday, December 23, 2005 11:22
PM
Subject: [Asterisk-Users] problem with
tdm400 fxo
Hi, I'm experiencing a very weird behaviour with my tdm400
with two fxo and one fxs modules. I setup my current configuration at home, I
tried it and it works flawlessly. I moved the computer to my office and
plugged the fxo to the wall plug, but when I tried to call I got a busy
signal. I attached the same wire to a phone, I called again and the phone
rang. I tried with both the fxo ports, but I always got a busy signal and on
the CLI Asterisk doesn't notice the incoming call at all. Outgoing calls do
not work either. So I moved again the computer to the home of a friend,
and it there it works too as it does at my place. When I plugged the TDM at
the office no other phone was plugged in the whole structure.
I'm
really puzzled and I don't know why it is behaving this way. Any hints?
Cheers, fc
_______________________________________________ --Bandwidth and
Colocation provided by Easynews.com --
Asterisk-Users mailing
list To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
|
_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --
Asterisk-Users mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users