Okay, since isdn4linux.de seems to block mails from schlund.de... On Fri, 30 Dec 2005, Armin Schindler wrote: > On Fri, 30 Dec 2005, Louis-David Mitterrand wrote: > > Hello, > > > > I just received a couple SX440isdn phones and was wondering if they can > > be plugged into a Diva 4BRI port in NT mode and work with > > asterisk+chan_capi? Yes, I don't know any reason why it shouldn't work. > > I know they probably work fine with mutliHFC cards with either bristuff > > of chan_misdn but since I have some spare Divas, I was curious about > > their potential as phone ports. > > > > The Diva's 3 and 4 ports are already set to NT mode at boot time: > > > > /sbin/divactrl load -SeparateConfig -c 1 -f ETSI -f1 ETSI -f2 ETSI -u2 > > -x2 -f3 ETSI -u3 -x3 looks good. > > And I think the capi.conf (using Armin's 0.6.1 version) looks OK: > > > > [DIVA2] > > ntmode=yes > > isdnmode=ptp > > incomingmsn=* > > controller=4 > > group=3 > > accountcode=diva > > context=international > > echosquelch=0 > > echocancel=no > > devices=1 isdnmode=ptp is wrong for chan_capi 0.6, use isdnmode=did > > But when I plug the phone into port 3 or 4 no led lights up, even with a > > Y plug and when dialing I get a busy. > > > > Before digging to deep, I am looking for some info on the feasability of > > that setup. What type of cable did you use? You need to use a crossed cable with 100 Ohm termination. Also, what version of driver/firmware do you use? Many enhancements are done (nt-mode too) in the latest drivers from Eicon source RPM.
Armin _______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- Asterisk-Users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users