It sounds like it might be dialplan instead of PRI related.
-bill
On 2-Jan-06, at 10:43 AM, Kristian Larsson wrote:
On Mon, Jan 02, 2006 at 03:36:57PM +0200, [EMAIL PROTECTED] wrote:
On Mon, 2 Jan 2006, Kristian Larsson wrote:
I have an Avaya IP Office PBX connected to an
Asterisk system via a Sangoma ISDN PRI card.
Dialing from the as
terisk system into the avaya works just fine but
when trying to call from a phone connected to the
avaya syste
m something goes wrong. After punching the first
four digits the Avaya calls out, shouldn't it wait
for all di
gits and then dial out?
If I try to dial a three digit number it waits for
a while then dials.
Is this some feature to let the CO know of which
area code the calls is going ahead of time?
Is there some way to circumvent this using hacks
on the asterisk side?
Looks like you need to enable overlapdial=yes on the Asterisk
side. It
will then wait for additional digits sent from the Avaya after the
initial
ones sent with the SETUP.
I did try enabling overlapdial=yes but I saw no
real change. Is there any other variable to go
with it that I might need to tune?
I am quite new to the whole PRI thing. What does
it do when setting up a call?
First a SETUP and after that it dials?
Regards,
Kristian
_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --
Asterisk-Users mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --
Asterisk-Users mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
