I thought the whole thing with the hardware echo cancellation is that it was basically in liu of the equivilent echo cancellation done in software... The reason to go to the hardware was for high-density systems?? For two FXOs, I thought I'd be safe in getting the non-echo cancellation cards, but perhaps no, huh?! :-( -Steve
________________________________ From: Lorentz Hinrichsen [mailto:[EMAIL PROTECTED] Sent: Wed 4/5/2006 8:56 AM To: Asterisk Users Mailing List - Non-Commercial Discussion Subject: Re: [Asterisk-Users] Frustrated with echo... http://www.voipsupply.com/index.php?cPath=99_359_360 A20002 no echo can = 359 A2002D with echo can = 659 Both above are with 4 FXO I don't know if these are the best prices you can find, but for comparison - from the same vendor: http://www.voipsupply.com/index.php?cPath=99_103 DGM-TDM04B = 378.90 The above is without echo can. There is no option for echo can, you are stuck tuning the gain, which when I tried - left my call volume too low or caused the echo to be worse! I agree that rebooting sometimes brings the digium card back to life. I've yet to have a problem with the Sangoma, also -- I have not tried their board without the echo cancellation. I'm thinking you'd be stuck adjusting the gain though. On 4/5/06, Steve Jones <[EMAIL PROTECTED]> wrote: Can you tell me what model Sangoma cards you're talking about?? The ones I saw that had HW echo cancellation were substantially more expensive than the Digiums.. I'm hoping I was looking at the wrong model or something! Thanks -Steve ________________________________ From: Lorentz Hinrichsen [mailto:[EMAIL PROTECTED] Sent: Tue 4/4/2006 10:48 PM To: Asterisk Users Mailing List - Non-Commercial Discussion Subject: Re: [Asterisk-Users] Frustrated with echo... I've had very poor results with the Digium cards, I am using a couple of the new Sangoma ones now (they are cheaper and have hardware echo cancellation). The digium boards proved almost impossible to completely eliminate echo, and I had random failures over time. On 4/4/06, Steve Jones <[EMAIL PROTECTED]> wrote: For phones, I've got a GS 101, a Sipura 841, and two analog phones hooked to an GS386 ATA (one phone per port). My troubles seem to be regardless of which phone is used, so I dont think it's on the phone-end of asterisk, but rather where I interface w/ Vonage and Verizon via POTS FXO... My SIP connections to the outside world have so far been good [frantically knocking on wood] I did go ahead and order the digium card yesterday evening, so I'm hopeful this will help. I had played with the gain, and was able to discern a difference, but it seemed to make some scenarios better, while making others worse, so I'm hoping the real digium card/drivers will just be smarter about handling it dynamically. Of course, my wife, who's a stay-at-home-mom is the biggest user of the system, but she's not interested in being a techy, so getting her to interrogate all callers about which number they dialed, etc.. and logging her opinions of the quality of the call hasn't worked! ;-) I also have some Cisco phones, but I haven't configured SCCP on my system yet, and dont want to use SIP on these phone (mostly to force myself to learn to configure SCCP on *) so that's another aspect that may help me after this weekend! Good point about the interrupts - I dont know the answer to that, but hopefully that'll also be a non-issue after I get the new card, and therefore have only one PCI slot handling everything. Thanks for the ideas!! -Steve ________________________________ From: Mike Dent [mailto:[EMAIL PROTECTED] Sent: Mon 4/3/2006 3:46 PM To: Asterisk Users Mailing List - Non-Commercial Discussion Subject: Re: [Asterisk-Users] Frustrated with echo... On 4/3/06, Steve Jones <[EMAIL PROTECTED]> wrote: > > I've been using my Asterisk (At my house - 2 modem-type fxos, and an > assortment of SIP endpoints for phones) for about 5 weeks now, and I've been > really happy with it, but I'm still having an echo problem that I've > exhausted google with, and can't get straight... > > I think I've determined that because I'm using $7 voice modem clones for my > FXOs that bad echo is going to just keep being a pain to me... I think I > should have only tried going through "proof of concept" state with them, > switching to something a little better quality when it was time to actually > commit to Asterisk. > > So, my question is "What's better and why: 1: a 'real' digium PCI card with > two fxo plugins, or using a couple external SIP fxo units like a > grandstream, zoom, or similar" Personally, I think it would be desirable to > keep the FXOs out of the asterisk box itself, just to give me future > flexability to move to whatever the platform of the day I want to put > asterisk on, without dealing with a PCI card to move, but if the consensus > is that the voice quality and support for the digium board is the best, then > that's what I'll do.. > > So, any comments on relative quality of these devices, and/or ones I've > missed? > 1: Grandstream HT-488 > 2: Zoom 5801/5802 > 3: DGM-TDM02B (TDM 400P with two FXOs) > > Are there any IAX2 FXOs that I'm missing? That seems to be an area that's > oddly not taken care of... > > Any hints would be greatly appreciated! Steve, I have a similar setup at home, although I am in the UK. I've got the echo fairly well under control, however it seems much less when using my Cisco 7960 rather than the Grandstrean BT102 phone. Have you tried dropping the gain? Have you made sure you have both cards on seperate IRQ's which are not in use by network, video etc? I disabled USB and on board audio in the BIOS to help free up IRQ's. I think your best option is the TDM400 card, or perhaps consider the Sangoma card with a dual FXO module, maybe slightly cheaper! I'd be interested what SIP phones you are using and if echo differs between them. Mike _______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- Asterisk-Users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users _______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- Asterisk-Users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
<<winmail.dat>>
_______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- Asterisk-Users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
