Sorry, I guess that would help! I was using an X100P so I am sure that was a large part of the problem.
-----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Paul Sent: Tuesday, June 06, 2006 1:38 PM To: Asterisk Users Mailing List - Non-Commercial Discussion Subject: Re: [Asterisk-Users] Vonage and FXO It would be helpful if responders would tell us what FXO hardware they are using and which vonage ATA device it connects to. Padmanaban Balasubramaniam wrote: >I am using it with my [EMAIL PROTECTED] setup. I did not face any issues with >echo, but >once in a while, the trunk does NOT get disconnected even after the call has >been completed. So I had to manually plug the phone cable out from FXO and >plug it back again. But I think that's something to do with my version of >FXO drivers. > >Otherwise it works for me. > >Paddu > >-----Original Message----- >From: [EMAIL PROTECTED] >[mailto:[EMAIL PROTECTED] On Behalf Of Curt Shaffer >Sent: Tuesday, June 06, 2006 10:37 AM >To: 'Asterisk Users Mailing List - Non-Commercial Discussion' >Subject: RE: [Asterisk-Users] Vonage and FXO > >I used a scenario like this before but I always ran into intermittent echo >issues that were just not worth the hassle for me so I switched to a sole IP >origination and termination service. > >Just my personal experience! > >HTH > >Curt > >-----Original Message----- >From: [EMAIL PROTECTED] >[mailto:[EMAIL PROTECTED] On Behalf Of mustardman29 >Sent: Tuesday, June 06, 2006 12:22 PM >To: asterisk-users@lists.digium.com >Subject: [Asterisk-Users] Vonage and FXO > > >Is anyone using Vonage on an FXO port in Asterisk? How well does it work? >Specifically, any echo/delay problems? > >Second part, I am assuming it is possible to separate fxo ports for least >cost routing correct? In other words, I would like the routing to be such >that any local or 1-800# dials fxo ports 1-4 which is a normal 4 line analog >PSTN connection. Any long distance call will try to dial fxo port 5 (Vonage >ATA) first and if it's used then use fxo ports 1-4. Is this easy to do in >FreePBX? > >I know I can get a Vonage softphone account and not use an ATA/FXO port. I >want to know if I can do it with an ATA/FXO. >_______________________________________________ >--Bandwidth and Colocation provided by Easynews.com -- > >Asterisk-Users mailing list >To UNSUBSCRIBE or update options visit: > http://lists.digium.com/mailman/listinfo/asterisk-users > >_______________________________________________ >--Bandwidth and Colocation provided by Easynews.com -- > >Asterisk-Users mailing list >To UNSUBSCRIBE or update options visit: > http://lists.digium.com/mailman/listinfo/asterisk-users > >_______________________________________________ >--Bandwidth and Colocation provided by Easynews.com -- > >Asterisk-Users mailing list >To UNSUBSCRIBE or update options visit: > http://lists.digium.com/mailman/listinfo/asterisk-users > > _______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- Asterisk-Users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users _______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- Asterisk-Users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users