I've asked this before but I don't recall seeing anyone respond. Maybe the answer is so simple that it should jump right out, but its not.
I've got three iax connections defined, two working fine (including one to iaxtel), and one that is somewhat intermitant. If I do a cli 'iax show registry' and 'iax2 show registry' I see "both" iax and iax2 registrations. Is there a way for me to config * to always use iax2 (and basically disallow iax registration), or should I not worry about it? The intermitant iax site is behind a CheckPoint firewall with udp/5036 open (but no udp/4569). I'm assuming the registration for both is working correctly since the * machine behind the CheckPoint is initiating the registration thus opening the nat map, etc. (My * is on a registered IP with no nat, etc.) What is somewhat confusing (at least for me) is the iax.conf entry in the [general] section that says port=5036 (and no port=4569). In this same file, I'm using: register => npi:[EMAIL PROTECTED] and a context of: [sai] type=friend context=from-sip secret=mypassword auth=plaintext host=dynamic trunk=yes and the dialplan includes: exten => _9.,1,Dial(IAX/npi:[EMAIL PROTECTED]/${EXTEN-1}) I understand how to insert Dial(IAX2/ in the dialplan. Should I be concerned at all on the incoming side? Rich _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users