Greetings and I thank you in-advance, I have a system installed with both Trixbox 1.x and 2.x installed and I am trying to utilize a wildcard x100p but it does seem hang-up or release the line. I understand that the Wildcards are not recommended, but I need to get a test system up for evaluation. Here are the steps followed:
Run genzaptelconf and red alarm appears in zttool Run again and it comes up ok Dial from SIP soft phone works great until hang up Card or asterisk does not seem to release the line. Any help would greatly be appreciated. /metta -----------------Diagnostics [EMAIL PROTECTED] ~]# ztcfg -vv Zaptel Configuration ====================== Channel map: Channel 01: FXS Kewlstart (Default) (Slaves: 01) 1 channels configured. [EMAIL PROTECTED] ~]# Current Alarms: Red Alarm â â â â Sync Source: Internally clocked â â â â â IRQ Misses: 0 â â â â â Bipolar Viol: 0 â â â â â Tx/Rx Levels: 0/ 0 â â â â â Total/Conf/Act: 1/ 1/ 0 [EMAIL PROTECTED] ~]# lspci 00:00.0 Host bridge: Intel Corporation 82810E DC-133 GMCH [Graphics Memory Controller Hub] (rev 03) 00:01.0 VGA compatible controller: Intel Corporation 82810E DC-133 CGC [Chipset Graphics Controller] (rev 03) 00:1e.0 PCI bridge: Intel Corporation 82801AA PCI Bridge (rev 02) 00:1f.0 ISA bridge: Intel Corporation 82801AA ISA Bridge (LPC) (rev 02) 00:1f.1 IDE interface: Intel Corporation 82801AA IDE (rev 02) 00:1f.3 SMBus: Intel Corporation 82801AA SMBus (rev 02) 01:07.0 Communication controller: Motorola Wildcard X100P 01:0c.0 Ethernet controller: 3Com Corporation 3c905C-TX/TX-M [Tornado] (rev 78) [EMAIL PROTECTED] ~]# _______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- asterisk-users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users