Which version of Zaptel and Asterisk are you using. If you have compiled Asterisk 1.4.2 with Zaptel 1.4.0 or a lesser version of Zaptel, you may face this problem.
Regards, Sanjay Rajdev ----- Original Message ----- From: "Greg Woods" <[EMAIL PROTECTED]> To: "Asterisk Users Mailing List - Non-Commercial Discussion" <[EMAIL PROTECTED]> Sent: Friday, April 13, 2007 9:29:43 PM (GMT+0530) Asia/Calcutta Subject: Re: [asterisk-users] Zap failure: cause 66 - Channel not implemented On Fri, 2007-04-13 at 07:46 +0200, Jose Limeres wrote: > when I try to make a call through the ZAP > channel get an error message about NO ZAP CHANNEL AVAILABLE. Ztcfg and > zttool show the card correctly installed. > When I tried to use the debug command ZAP SHOW, it was not present in > the CLI. This almost surely means that when you compiled asterisk, it did not detect that you had the Zaptel drivers. I had this happen to me and I beat my head against the wall for quite a while before I figured it out. You must compile and install the zaptel driver first, then compile asterisk. --Greg _______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- asterisk-users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users _______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- asterisk-users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users