Eric,
Thanks when I took the rx and tx to 0.0 on both the caller id showed up
I guess I will play with. My main reasoning for adjusting the rx and tx
was to get rid of the echo...What other tips do you suggest or anyone
out there? Thank you!
--------------------------------------------
Otis Surratt Jr. / [EMAIL PROTECTED]
OCOSA Communications, LLC
PH: 918.585.9882 x 205 Fax: 918.585.5857
Visit Tulsa's Best Internet Data Center:
http://www.ocosa.com/hosting/colo/index.asp
--------------------------------------------
Eric "ManxPower" Wieling wrote:
OCOSA ListAcc wrote:
Eric,
I have watched the CLI before and it said nothing although I did
change the position of the callerid = asreceived to right below and
nothing it still shows up on the phones "asterisk" and in voice mail
sent via e-mail unknown caller:
Here is an output from a while back but it stopped so I do not know
what is up.....
-- Starting simple switch on 'Zap/1-1'
Apr 6 16:54:39 ERROR[4726]: callerid.c:276 callerid_feed: fsk_serie
made mylen
< 0 (-92)
Apr 6 16:54:39 WARNING[4726]: chan_zap.c:6255 ss_thread: CallerID
feed failed:
Success
Apr 6 16:54:39 WARNING[4726]: chan_zap.c:6299 ss_thread: CallerID
returned with
error on channel 'Zap/1-1'
These errors usually indicate that your rxgain for the FXO ports is
either too high or too low. Change the rxgain in
/etc/asterisk/zapata.conf in increments of 2 either up or down until,
but you generally don't want it to be less than -10 or greater than
10. "reload chan_zap.so" should apply the gain changes.
_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --
asterisk-users mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --
asterisk-users mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users
