(Note: resending with proper Subject) If I use Asterisk to initiate two call legs with a callfile, dialing the channel and setting the extension to an AGI that dials another channel, and both dial by SIP connection to a switch that allows only G.729, do I need a G.729 codec running on Asterisk? Do I need 2?
And if I use the callfile to connect by SIP to a switch that allows only G.729, then use the extension AGI to play a file pre-encoded in G.729, do I need a codec? Where is the SW that encodes files in G.729? On Thu, 2007-05-17 at 08:38 -0700, [EMAIL PROTECTED] wrote: > Date: Thu, 17 May 2007 11:22:17 -0400 > From: "Race Vanderdecken" <[EMAIL PROTECTED]> > Subject: RE: [asterisk-users] cpu usage for G.729 codec > To: "'Asterisk Users Mailing List - Non-Commercial Discussion'" > <asterisk-users@lists.digium.com> > Message-ID: <[EMAIL PROTECTED]> > Content-Type: text/plain; charset="us-ascii" > > > G.729 is a compromise of bandwidth vs. CPU power. It takes more CPU > but > less bandwidth. > > It depends on what your want to do with the G.729. > > Pass through does not involve any transcoding, that I know of, so it > is > just an RTP packet movement, no different than the cost of other pass > through codecs. > > I did work on converting G.729 to G.711 to disk storage in real time > and > that took about 3% of a Xeon CPU for full duplex. > > Memory wise each convert call might have used 640KB in buffers and > trash, but not much. -- (C) Matthew Rubenstein _______________________________________________ --Bandwidth and Colocation provided by Easynews.com -- asterisk-users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users