I wish to connect * to a Cisco using a E100P board.
When I load the driver I got this error message:
-bash-2.05b# modprobe wct1xxp ZT_CHANCONFIG failed on channel 1: Function not implemented (38) /lib/modules/2.4.21-SAX/misc/wct1xxp.o: post-install wct1xxp failed /lib/modules/2.4.21-SAX/misc/wct1xxp.o: insmod wct1xxp failed
Follows Cisco configuration:
isdn switch-type primary-qsig isdn voice-call-failure 0
controller E1 2 framing NO-CRC4 clock source line primary pri-group timeslots 1-31
interface Serial2:15 no ip address isdn switch-type primary-qsig isdn overlap-receiving T302 2000 isdn incoming-voice modem isdn T310 40000 isdn send-alerting no cdp enable
voice-port 2:D cptone BR
I configured my /etc/zapata.conf:
span=1,0,0,ccs,hdb3 nethdlc=1-15
Any clue?
Thanks in advance,
Daniel
_______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users
