. . . > What version of asterisk is it? 1.4.4
> What is the output of: > > cat /proc/zaptel/* Span 1: ZTDUMMY/1 "ZTDUMMY/1 (source: RTC) 1" Span 2: WCTDM/0 "Wildcard TDM400P REV I Board 1" 1 WCTDM/0/0 FXOKS 2 WCTDM/0/1 FXOKS 3 WCTDM/0/2 FXSKS 4 WCTDM/0/3 FXSKS (ztdummy was in the base install, I have removed that in the past, but do not recall how, will research) > asterisk -rx 'zap show channels' xxx~ # asterisk -rx 'zap show channels' No such command 'zap show' (type 'help' for help) help does not show 'zap' at all core show channels says 0 active channels 0active calls >> >> zaptel.conf - >> >> defaultzone=us >> loadzone=us >> fxoks=1,2 >> fxsks=3,4 >> >> zapata.conf >> >> [channels] >> >> signalling=fxo_ks >> language=us >> context=phones-1 >> group=0 >> ##switchtype=national >> ##pridialplan=national > > Use ';' for comments. '#' are for preprocessor directives. This happens > to also disable almost any line, but also create an annoying warning in > the logs. corrected > Have you looked at the logs, BTW? Which? /var/log/messages show the card being detected and apparently initialized. >> channel=1 > > This only defines the first port . What about 2? Was not going to use that, in this initial setup. >> >> signalling=fxs_ks >> language=us >> context=line-1 >> group=0 >> ##switchtype=national >> ##pridialplan=national >> channel=4 > > Same comments: what about 3? same as above, but I added them, regardless. > It is also normally kind of pointless to put both phones and POTS lines > in the same group (group 0, in your case). corrected. joe a. _______________________________________________ -- Bandwidth and Colocation Provided by http://www.api-digital.com -- asterisk-users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users