Try to build a local loop cable first Loop pins 1-4 and 2-5 and connect to e1 port of your card. You should see the green light instead of red on card physically and ur alarm should go green too http://wiki.sangoma.com/Cablepinouts check here for cable diagram
> Hi, I have been trying to get a Wildcard TE122 card running here the > last couple of days. > > libpri and zaptel are all installed and configured to E1 specs. The > jumper on the card is on, so configured for E1 (I'm in Norway). > > When running zttool, I get 'Alarms: RED' on the single card installed. > Other information in zttool: > Current alarms: Red Alarm > Sync source: Internally clocked > IRQ Misses: 1 > Bipolar viol: 0 > Tx/Rx levels: 1/0 > Total/conf/act: 31/31/0 > > There are no IRQ conflicts (cat /proc/interrupt shows only wcte12xp0 on > the relevant IRQ) > > The result is the same with or without cable inserted. > > The layout is: > TE122-[3m cable]-[~50m cable]-[NT1 ISDN box from Telenor] > > When inserting the cable going into TE122 into an ISDN phone, the phone > works perfectly. > > Any suggestions would be greatly appreciated :-) > _______________________________________________ > -- Bandwidth and Colocation Provided by http://www.api-digital.com -- > > asterisk-users mailing list > To UNSUBSCRIBE or update options visit: > http://lists.digium.com/mailman/listinfo/asterisk-users _______________________________________________ -- Bandwidth and Colocation Provided by http://www.api-digital.com -- asterisk-users mailing list To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users
