On Wed, Feb 18, 2004 at 05:08:52PM -0600, Martin Pycko wrote: > You can also do R1 to do descending round-robin. Same with G1 and g1. > > Martin > > On Wed, 18 Feb 2004, Steve Creel wrote: > > > I've not seen it documented anywhere, but scrolled past it the other day > > in chan_zap.c. > > > > Apparently you can specify a zap group with an 'r' instead of a 'g' to use > > the group in round-robin. > > > > I looked but didn't find anything in the archives on this, so I figured > > I'd mention it.
While we're on the subject... Somewhere in the documentation (I think it's in the draft v2 handbook) it says that Zap groups act differently if they're FXS vs. FXO. Basically, it say's * will take first available when their call-out (FXO) lines, and * will ring all lines when they're FXS. I was not seeing the latter behavior. I had a group defined that included all of my FXS ports, and when did this for incoming calls, it rang only one FXS port -- the first available... exten => s,1,LookupCIDName exten => s,2,Dial(Zap/g2,20,t) Anybody want to suggest where I look next, or is the handbook referring to something that hasn't been implemented yet? Rob -- Rob Fugina, Systems Guy [EMAIL PROTECTED] -- http://www.geekthing.com My firewall filters MS Office attachments. Squirt guns don't soak people, People soak people. _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users