I have the same problem in Spain, but I did not start to change any config. Is this problem because of the phone or because of the TDM card? Did u get a solution?
Hiep > -----Ursprüngliche Nachricht----- > Von: [EMAIL PROTECTED] [mailto:asterisk-users- > [EMAIL PROTECTED] Im Auftrag von bam > Gesendet: Freitag, 7. Mai 2004 19:31 > An: [EMAIL PROTECTED] > Betreff: RE: [Asterisk-Users] Missing digits on TDM400P incomplete dial > string - DTMF problem? > > I turned down the rxgain and txgain to -22.0 and -16.0 respectively and > things started to look a whole lot more acceptable. Then the client > sticks > on his BT DECT phone and I start losing all the "1"s from the dial string. > > > Does anyone know if BT DECT phones have dodgy DTMF tones? > > At 17:19 07/05/04, you wrote: > >I've had a quick fiddle to little avail, the readings looked prey good > to > >be honest before I started fiddling. Looking a little closer it appears > >that it is the digit "1" that is being lost more that any other. > > > > > > > >At 15:25 07/05/04, you wrote: > >>Run /usr/src/zaptel/ztmonitor 32 -v > >>And adjust your gains in /etc/asterisk/zapata.conf accordingly. > >> > >>Gregory P. Scasny > >> > >>Golden Technologies Inc. > >> > >>http://www.golden-tech.com > >> > >>219-462-7200 > >> > >>-----Original Message----- > >>From: [EMAIL PROTECTED] > >>[mailto:[EMAIL PROTECTED] On Behalf Of bam > >>Sent: Friday, May 07, 2004 3:35 AM > >>To: [EMAIL PROTECTED] > >>Subject: [SPAM] - [Asterisk-Users] Missing digits on TDM400P incomplete > >>dial string - Email found in subject > >> > >>We are experiencing problems on a FXS interface where the client is > >>dialing > >>numbers, but digits are being dropped somewhere from the dial string. > >>Typically one or two digits are not being presented. We've tried > >>different > >>handsets to no avail, and I am assuming that it is some sort of timing > >>problem. > >> > >>Are there any parameters I can tweak to try and rectify this? > >> > >> > >>zapata.conf > >> > >>context=hardwire > >>group=3 > >>signalling=fxo_ks > >>mailbox=8765 > >>callerid="Acme" <8765> > >>channel=32 > >> > >> > >> > >> > >>extensions.conf > >> > >>[hardwire] > >>; > >>exten => _NXXXXXX,1,SetCallerID(0141411${CALLERIDNUM}) > >>exten => _NXXXXXX,2,CallingPres(3) > >>exten => _NXXXXXX,3,Dial(Zap/g1/0141${EXTEN}) > >> > >>exten => _0.,1,SetCallerID(0141411${CALLERIDNUM}) > >>exten => _0.,2,CallingPres(3) > >>exten => _0.,3,Dial(Zap/g1/${EXTEN}) > >> > >>exten => t,1,Hangup ; If they take too long, give > >>up. > >>exten => i,1,Hangup ; If they get it wrong, give up > >> > >> > >>_______________________________________________ > >>Asterisk-Users mailing list > >>[EMAIL PROTECTED] > >>http://lists.digium.com/mailman/listinfo/asterisk-users > >>To UNSUBSCRIBE or update options visit: > >> http://lists.digium.com/mailman/listinfo/asterisk-users > >> > >> > >>_______________________________________________ > >>Asterisk-Users mailing list > >>[EMAIL PROTECTED] > >>http://lists.digium.com/mailman/listinfo/asterisk-users > >>To UNSUBSCRIBE or update options visit: > >> http://lists.digium.com/mailman/listinfo/asterisk-users > > > > > >_______________________________________________ > >Asterisk-Users mailing list > >[EMAIL PROTECTED] > >http://lists.digium.com/mailman/listinfo/asterisk-users > >To UNSUBSCRIBE or update options visit: > > http://lists.digium.com/mailman/listinfo/asterisk-users > > > _______________________________________________ > Asterisk-Users mailing list > [EMAIL PROTECTED] > http://lists.digium.com/mailman/listinfo/asterisk-users > To UNSUBSCRIBE or update options visit: > http://lists.digium.com/mailman/listinfo/asterisk-users _______________________________________________ Asterisk-Users mailing list [EMAIL PROTECTED] http://lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: http://lists.digium.com/mailman/listinfo/asterisk-users