DID is "inbound" only. DID will not work if you plan to use the same trunks for outbound calls. Do the Digium cards support DID? Normally DID lines require an external power supply which connects to the card. I don't remember seeing anything like that on the Digium analog cards.
Question 5 will be harder. What you need is DID ( Direct Inward Dialing) Not available in my area with regular phone lines. Perhaps it could be done with distinctive ring????? Gavin ----- Original Message ----- From: Mike Stupak To: [EMAIL PROTECTED] Sent: Monday, May 17, 2004 4:59 PM Subject: [Asterisk-Users] total newbie sanity check Iâm a total newbie at this telephony stuff but I'm putting together a low cost PBX for my small company and wanted a check on the h/w Iâm planning on ordering and my system configuration. Any input is appreciated. Take it offline and email me directly if appropriate ([EMAIL PROTECTED]). Hereâs what Iâm planning: === Parts List === 1 Digium Wildcard TDM400P w/ 4-port FXO bundle Iâm planning on using this to connect to a few CO POTS lines. A mid-range computer (600MHz or so w/ 512 MB RAM) Some form of Linux (fedora?) Asterisk 10/100 Ethernet card (in the computer) 10/100 Ethernet Switch (8 port or so) A few SIP capable phones === End Parts List === And now a few questions:
Thatâs all for now (though Iâm sure this wonât be my last post. Thanks again for any help. - Mike Stupak |
<<inline: graycol.gif>>
<<inline: pic15724.gif>>
<<inline: ecblank.gif>>